Simple hardware and software solution to detect where a serial device is connected.
This is a simple hardware and software solution I created to detect where a serial device is connected.
We had this issue in our company to detect in what serial port on Windows a device was connected. Usually the computers we found in the field had several serial devices
and to find the correct serial port was painful. People usually selected the incorrect serial port.
We already tried to detect where the device is by sending some bytes and checking the return value, but as we do not know what each device might return it doesn’t work sometimes.
So the solution was a physical one, disconnect the device we want to detect the serial port, plug our serial loopback and let our software detect our device instead of the original one.
If you have a problem like this try this solution in three simple steps.
This is the hardware part.
What we need is a device that sends back what it receives. It was easy because the serial interface is so old and, in this case, old means simple.
To create this device we need:
Below you can see a diagram of the pins that must be welded.
Weld the pin 2 (TX) to the pin 3 (RX). This way any data that leaves the serial port from TX will return to the computer in RX.
We also need to weld the ground pin 5 (GND) to the computer. Simply weld it to the connector, and that’s it.
This is the software part.
In this part we need a piece of code to iterate over the serial ports writing some bytes. After we write we read it back.
If what we read is the same as what we wrote, it means we found our serial loopback.
I wrote a sample application in Go. You can find the source code in this repository file serial_windows.go.
Now the final part.
Connect your serial loopback device in the serial port you want to detect and run the sample program.
You should see the following output:
D:\projects\serial>serial.exeloopback found on: COM5
It means the serial loopback was found on COM5 in this case.
Hope it helps you!